First Time Yield

In this chapter, we will cover the concept of yield. Yield is the percentage of error free output in a given step of a process. We use this to analyze a process and identify problem areas where we need to focus for continuous improvement. This is calculated in two different manners. One is called the first time yield, and the other is called rolled through yield. The first time yield is typically examined at the top level for a process, whereas the rolled through yield could look at the entire end to end process. For example, I once worked with a large team that was examining the first time yield and the rolled through yield in an automotive assembly plant. At each of the stations we measured the percentage of defects while moving through the process. We rolled all of that up and found out that the rolled through yield for the entire automotive assembly plant was only about 21%. Meaning 79% of everything had to be reworked or fixed in some fashion, before it got to the end of the line. This gave us the basis to go back and identify which relatively few stations needed the most attention, so that we could improve the overall roll through yield.

Let’s consider an example of first time yield. We have 10,000 units entering a step in the process, but we have to scrap or rework 1,000 units, so we end up with 9,000 acceptable units. If we do the calculation of the 9,000 divided by the original 10,000, we would find that our first time yield, also called first pass yield, would be 90%. Let’s calculate first time yield. We take the number of units with no defects and divide that by the total units inspected. We then multiply this number by 100. This gives us the percentage of the units that make it through the process defect free. Let’s say that we had 18,230 units that we processed with no defects, out of a total of 20,500 units that we actually inspected. We divide the 18,230 by 20,500 and we get to 0.889. We multiply that by 100 to determine a first time yield of 88.9% for this process.